RDOG
|
Joined:
Jun 2001
Ontario. California U.S.A.
|
|
Can someone please give me the thread to convert 1 wire to 3 wire. Thanks
1986 Turbo Coupe. Boport StageIII head, Boport 2.1, Performance Techniques 50 trim hybird, StageII.63, stinger 3" exhaust, Phenolic spacer, Boglog header,NPR FMIC intercooler setup, kirban fpr, bigrmotorsports fuel rail, diablo water meth kit, CAI, remote mount TFI, CHE rear adj control arms, MAC girdle, 8.8 rear disc, aluminum drive shaft, H&R lowerings springs Tbird Turbo Specific, y MAS!!
|
Joe F
|
Joined:
Jul 2002
Hawkins, Texas - USA
|
|
Don't know where the thread is (didn't even know there was one) but the three wires are ground and +12 volt power for the heating element and then the sensor output lead. Connect the wires accordingly and you should be good to go. Also, I could be wrong here but IIRC the +12 line that supplies the injectors is also used for the O2 sensor +12.
HTH.
|
RDOG
|
Joined:
Jun 2001
Ontario. California U.S.A.
|
|
Thanks Joe
1986 Turbo Coupe. Boport StageIII head, Boport 2.1, Performance Techniques 50 trim hybird, StageII.63, stinger 3" exhaust, Phenolic spacer, Boglog header,NPR FMIC intercooler setup, kirban fpr, bigrmotorsports fuel rail, diablo water meth kit, CAI, remote mount TFI, CHE rear adj control arms, MAC girdle, 8.8 rear disc, aluminum drive shaft, H&R lowerings springs Tbird Turbo Specific, y MAS!!
|
