North American Turbocoupe Organization



What do you think of my crank seal alignment tool
RDOG Offline
Posting Freak
#1
The guy at opmd doesnt carry them anymore so I had one made. It is made from 6061 alumiunm and is easier to remove and install.

Check it out....
http://i158.photobucket.com/albums/t97/b...olmain.jpg
http://i158.photobucket.com/albums/t97/b...ol/top.jpg
http://i158.photobucket.com/albums/t97/b...altool.jpg
http://i158.photobucket.com/albums/t97/b...langle.jpg
http://i158.photobucket.com/albums/t97/b...inside.jpg
http://i158.photobucket.com/albums/t97/b...ighton.jpg

Comments welcome
1986 Turbo Coupe. Boport StageIII head, Boport 2.1, Performance Techniques 50 trim hybird, StageII.63, stinger 3" exhaust, Phenolic spacer, Boglog header,NPR FMIC intercooler setup, kirban fpr, bigrmotorsports fuel rail, diablo water meth kit, CAI, remote mount TFI, CHE rear adj control arms, MAC girdle, 8.8 rear disc, aluminum drive shaft, H&R lowerings springs Tbird Turbo Specific, y MAS!!
Reply

Paulie Offline
Banned
#2
Thats a nice job I always like home made tools. What i do is when i aligh the cover with my tool i drill 2 pilot holes in the cover and the block and install 2 aligning pins so the cover is perminately aligned forever. Nice Tool.
Reply

Jeff K Offline
Administrator
#3
Looking good! Much nicer than the OMPD one I have.
Jeff Korn

88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 24 psi, forced air IC, water injection, BPV, Ranger cam, subframes, etc., etc.
86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP N2O, ignition, gears, suspension, etc., etc.
11 Crown Vic Interceptor
14 Toyota Camry (wifes car)
95 Taurus GL Vulcan winter beater
67 Honda 450 Super Sport - completely customized
Reply

etc1006 Offline
Member
#4
Nice! You always come up with the coolest ideas and goodies.
-Eric
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB