Chris Ruhl
Joined:
May 2001
Oakley,M.I.,48649
|
|
Can you buy new turbo rebuild kits to rebuild a Garret T3 turbo?
|
Blade1433
Joined:
Jun 2001
Columbus, Ohio, USA
|
|
Yes(!), you can. They're on Ebay for around $100 but pretty much useless if the turbine has hit the housing...
------------------
Blade
"Drive it like you stole it"
88 bone stock TC with 138k, 5spd, burgundy, almost all options with new U-joints, tranny Xmember, front end, FULL tune-up with select MSD products, new horizontal axle shock thingies, custom interior, white face guages. Coming soon: boost guage and air fuel ratio guage on the pillar, Gillis valve, K&N, gutted upper, knife edged lower, gutted E6, T3, and steam cleaned engine bay.
|
Pete D
Joined:
Apr 2001
Northern OH
|
|
Like Blade said, yes you can get them, from just about any turbo shop. See the link for Turbonetics on the Vendors page or look in the phone book for a local shop in your area.
------------------
NATO Member
88 TC X 2, 86 SVO, Main TC with K&N, 3"DP to 2.5"duals through Dynamax, Ric valve at 17+ and disconnected KS.
Elite Bodega 16" chrome wheels. Autometer pod w/ A/F and Vac/boost gauges.140 mph Motorsports Speedo New engine: Total Seal rings and TRW pistons, ported and polished head w/ cc'd chambers,1.59"exhausts, SS valves, gutted upper, knife edged lower, A-230 cam, Race Engineering Adj Cam Sprocket, Crowlers, ARP head studs, and rod bolts. Walbro 255 HP pump and Kirban adj FPR, T-3. Centerforce II, KB subs and jack rails.
Pete Dunham
|