North American Turbocoupe Organization

Turbo rebuild kits?
Chris Ruhl Offline
Can you buy new turbo rebuild kits to rebuild a Garret T3 turbo?

Blade1433 Offline
Senior Member
Yes(!), you can. They're on Ebay for around $100 but pretty much useless if the turbine has hit the housing...


"Drive it like you stole it"

88 bone stock TC with 138k, 5spd, burgundy, almost all options with new U-joints, tranny Xmember, front end, FULL tune-up with select MSD products, new horizontal axle shock thingies, custom interior, white face guages. Coming soon: boost guage and air fuel ratio guage on the pillar, Gillis valve, K&N, gutted upper, knife edged lower, gutted E6, T3, and steam cleaned engine bay.

Pete D Offline
Like Blade said, yes you can get them, from just about any turbo shop. See the link for Turbonetics on the Vendors page or look in the phone book for a local shop in your area.

NATO Member
88 TC X 2, 86 SVO, Main TC with K&N, 3"DP to 2.5"duals through Dynamax, Ric valve at 17+ and disconnected KS.
Elite Bodega 16" chrome wheels. Autometer pod w/ A/F and Vac/boost gauges.140 mph Motorsports Speedo New engine: Total Seal rings and TRW pistons, ported and polished head w/ cc'd chambers,1.59"exhausts, SS valves, gutted upper, knife edged lower, A-230 cam, Race Engineering Adj Cam Sprocket, Crowlers, ARP head studs, and rod bolts. Walbro 255 HP pump and Kirban adj FPR, T-3. Centerforce II, KB subs and jack rails.
Pete Dunham


Users browsing this thread:
1 Guest(s)

Theme © iAndrew 2018 - Software MyBB