North American Turbocoupe Organization



tubing bender
trashline Offline
Posting Freak
#1
Im an expert at this. everytime (3 ) I broke a oil supply line for the turbo I had to make a new one. I used brake line and a snapple bottle. Any small glass bottle will work but since the tubing is ment to bend it worked like a charm.

so a small glass bottle like a snapple bottle
Brian

www.BCPCustom.com

06 Cobalt SS
66 mustang 289 C4 handfully modded

Stingers IC install and tbird photos
http://community.webshots.com/user/trashline
Reply

Qwertys Offline
Senior Member
#2
I made one for my 1/2" tubing by getting some of those slotted bars (for shelving, ect found at any good hardware store) and some of the pipe stoppers that have a bolt going through the middle (tighten the bolt and it squeses the rubber middle to strech out). put some washers inbetween them instead of the rubber, get two of them, mount it on the bar, and you have a good pipe bender. yea it crushes the inside a little but its great for tight bends.
'85 TC BPV and Ford FMIC
'88 TC Kirban AFPR, Autometer Boost, FP and A/R Gauge, 8.8 to 4.10 rear, Walboro 255lph Fuel pump, Garrett GT3071R T3/T4 Dual Ball bearing Turbo, Custom AWIC.
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB