North American Turbocoupe Organization



throttle body removal
turbocoupe88 Offline
Senior Member
#1
I want to remove my throttle body so that I can get to the valve cover. This might be a dumb question but how do i take off the two linkage type wires that run to the gas pedal inside the car off of the throttle body?
1985.5 Turbocoupe
Previous- 1988 Turbocoupe
http://www.geocities.com/boosted4d/1985Turbocoupe.html
Reply

86tc Offline
Member
#2
It's like a ball-and-socket joint. You just have to push down until it pops off. It's not hard, just be careful not to break the plastic.

Rick
'62 Ranchero (in progress...again)
'72 Gran Torino Sport (for sale/trade)
'76 Honda CB750 (for sale/trade)
'88 Yamaha Blaster Race 4-wheeler (for sale/trade)
'89 Lincoln Town Car (for sale/trade)
'92 GMC Safari Conv. Van (for sale)
'94 Pontiac Bonneville
'96 GMC Jimmy
Reply

Pete D Offline
Administrator
#3
Use a long screw driver to pry it toward the front of the car. you only have to remove the onewhere the cables are side by side. It is easier to remove the TB and upper intake as a unit then remove the TB from the upper on the bench.

------------------
NATO Member. it's not a vice, it's an obsession
"The nice thing about each new day is nobody ever used it before" Barnaby Jones
88 TC X 2, 86 SVO, mods list at
http://www.turbotbird.com/showroom/pd_88tc.htm
Pete Dunham


Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB