North American Turbocoupe Organization

T-3 rebuild info
Seanm5005 Offline
I was wondering if anyone had suggestions or info on rebuilding a T-3. I found it had play in the bearings, but neither turbines have came in contact with the housing. I did find that the shaft has grooves where the bearings ride. So the out of tolerance problem with shaft replacement and a rebuild kit is what I am looking for. Thanks Sean

Pete D Offline
If it was just seals and bearing, you might be OK, but wiht a shaft needing replaced, the assy ought to be balanced. Or try to find a rebuilt center section that has already been balanced.

NATO Member. it's not a vice, it's an obsession
Letting the cat out of the bag is a whole lot easier than putting it back in.
88 TC X 2, 86 SVO, mods list at
Pete Dunham


Seanm5005 Offline
Thanks Pete.

Users browsing this thread:
1 Guest(s)

Theme © iAndrew 2018 - Software MyBB