vfast
|
Joined:
Jul 2006
richmond,Va
|
|
pulled off the intake tract the t/b full of hard carbon..tps was set at .99 I set it about .94 had to enlongate the holes...idles smoother but idles around 1025 rpms...installed new wires..
finally saw a lil bit brake fliud leak on the ground seem to be near the master cyl. I believe i 'm going to pull off the master cyl.. does anyone know if they make a rebuild kit?
I just can't quit on it...I never let a car beat me
|
Pete D
|
Joined:
Apr 2001
Northern OH
|
|
I don't think there is a rebuild kit for the MC
Not sure but give these folks a call:
"SIA Electronics Inc. Seem they repair these things
Might call them if you need parts and see what they charge. 800-327-6338. They are in DuQuoin, IL 62383"
Pete Dunham
|
vfast
|
Joined:
Jul 2006
richmond,Va
|
|
thx!!!!
hey is that 1025 rpm idle about right?
|
Jeff K
|
Joined:
Apr 2001
Milwaukee, WI
|
|
Check to see if the leak is coming from the PRC pressure switch on the line under the MC. While it isnt real common for these switches to leak, it isnt unheard of either.
Jeff Korn
88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 24 psi, forced air IC, water injection, BPV, Ranger cam, subframes, etc., etc.
86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP N2O, ignition, gears, suspension, etc., etc.
11 Crown Vic Interceptor
14 Toyota Camry (wifes car)
95 Taurus GL Vulcan winter beater
67 Honda 450 Super Sport - completely customized
|
