North American Turbocoupe Organization



Some EEC questions...
Kuch Offline
Senior Member
#1
So I pulled some codes from the 88, there are two that I'm not sure about how to fix. First, KOEO code 67 neutral drive switch/AC input high. What is the fix for that? Second is CM code 34 EGR insufficient flow. Is this a bad EGR or just needs a cleaning? Car has 103,000 miles on it, not sure if the valve has ever been replaced. Also, how do I clear the codes with the jumper? I know I read on here somewhere but cannot find where? Thanks
1988 Turbo Coupe, Black/Black, 5 Speed, Moonroof,  T3/T4, ported E6, 255LPH, Kirban, Stinger Exhaust, MGW shifter, K&N, Gillis valve, BP1.5, PIMPx, Koni's
1964 Ford Galaxie 500XL, 390 6V, Big Solid cam, Headers,3.89's, 4 Speed, Vast and fast
1960 Ford Starliner, 292 Y Block, 312 4bbl intake, headers, 3 Speed, slow and low
Reply

Jeff K Offline
Administrator
#2
Was the AC turned on when the test was run? If so, ignore the 67.

Pull the EGR valve and see if it is carboned up. Also be sure it opens with vacuum applied and the vac lines from vac manifold to EVR solenoid and solenoid are intact and connected.
Jeff Korn

88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 24 psi, forced air IC, water injection, BPV, Ranger cam, subframes, etc., etc.
86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP N2O, ignition, gears, suspension, etc., etc.
11 Crown Vic Interceptor
14 Toyota Camry (wifes car)
95 Taurus GL Vulcan winter beater
67 Honda 450 Super Sport - completely customized
Reply

Jeff K Offline
Administrator
#3
Was the AC turned on when the test was run? If so, ignore the 67.

Pull the EGR valve and see if it is carboned up. Also be sure it opens with vacuum applied and the vac lines from vac manifold to EVR solenoid and solenoid are intact and connected.
Jeff Korn

88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 24 psi, forced air IC, water injection, BPV, Ranger cam, subframes, etc., etc.
86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP N2O, ignition, gears, suspension, etc., etc.
11 Crown Vic Interceptor
14 Toyota Camry (wifes car)
95 Taurus GL Vulcan winter beater
67 Honda 450 Super Sport - completely customized
Reply

Kuch Offline
Senior Member
#4
I did have the heat on defrost and floor, so that should be running the A/c compressor if it's like most other Fords. So the test should be run with no hvac turned on then, I have the EATC on mine so next test will be with it off. I'll pull the EGR and give it a good cleaning and once over
1988 Turbo Coupe, Black/Black, 5 Speed, Moonroof,  T3/T4, ported E6, 255LPH, Kirban, Stinger Exhaust, MGW shifter, K&N, Gillis valve, BP1.5, PIMPx, Koni's
1964 Ford Galaxie 500XL, 390 6V, Big Solid cam, Headers,3.89's, 4 Speed, Vast and fast
1960 Ford Starliner, 292 Y Block, 312 4bbl intake, headers, 3 Speed, slow and low
Reply

Pete D Offline
Administrator
#5
You can erase codes by disconnecting the STI circuit while the CM codes are being reported.
Pete Dunham


Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB