North American Turbocoupe Organization



shifter boot.......
Thndrchckn420 Offline
Senior Member
#1
does anyone sell an aftermarket shifter boot?
88 5-spd. Precision SC-50 ball bearing turbo, gillis, full 3" exhaust w/ 3- 1/2 crome tip, ported E-6, ported big exhaust valve head, ranger roller cam, Essy cam gear, K&N cone in front of the radiator, gutted upper, knife edged lower, Walbro 255HP pump, Kirban AFPR, Forge BPV, PA Performance 130 AMP Alt...
Reply

Pete D Offline
Administrator
#2
I haven't heard of anyone that does. Don't know if somethin gform another car (Mustang??) will work or not. I have a couple extras. If your interested e-mail me.

------------------
NATO Member. it's not a vice, it's an obsession
Good judgement comes from bad experience, and a lot of that comes from bad judgment.
88 TC X 2, 86 SVO, mods list at
http://www.turbotbird.com/showroom/pd_88tc.htm
Pete Dunham


Reply

kwiksilver3441 Offline
Member
#3
i made my own (with a little help from my wife in the sewing part) I purchased some grey vinyl fabric from walmart for $4.33 a yard. just cut out 5 11" tall by 6" wide triangles and sew them together. looks awesome with the tc grey interior.
Reply

Cthulhu Offline
Junior Member
#4
I put a shift boot out of a mustang into my tc. It was a little shorter but that worked better because I run a short shifter. Oh yeah I put it in backwards as well. It didn't need to go in that way I just noticed it after it was all together again, just kinda said F it and it works fine, doesn't even look funny! lol

------------------
'84 turbo, electronics died and I had this 302 short block in the basement........ this summer I should have about 350/350 hp/lbft and I can tune it with a screw driver. try that with a honda!
'84 turbo, electronics died and I had this 302 short block in the basement........ this summer I should have about 350/350 hp/lbft and I can tune it with a screw driver. try that with a honda!
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB