North American Turbocoupe Organization



Replacing PRC Strut Mounts - 87 TC
vegas_ss Offline
Senior Member
#1
After searching, I found that some have replaced the strut mounts without any problems. There was some discussion about needing to use a washer or two for the PRC actuator to mount up.

Is this a certain brand of strut mount that required the washers or do all replacements need them? Any recommendations on which ones to use?

Also... do the MM caster/camber plates work with the PRC strut? I thought I read that it doesn't on the MM site, but can't find that info and haven't come across anyone using them with the PRC's.
1987 TC, 5sp, Boport Stage 3 Head/2.1 Cam
1996 Impala SS, DCM, Borla Cat Back, too much other stuff!!! (SOLD)
2009 Pontiac G8 GXP 6M, 6.2l LS3, Kooks Long Tube, Hi Flo Cats, Mild Cam
Reply

vegas_ss Offline
Senior Member
#2
Anyone?
1987 TC, 5sp, Boport Stage 3 Head/2.1 Cam
1996 Impala SS, DCM, Borla Cat Back, too much other stuff!!! (SOLD)
2009 Pontiac G8 GXP 6M, 6.2l LS3, Kooks Long Tube, Hi Flo Cats, Mild Cam
Reply

Pete D Offline
Administrator
#3
http://natomessageboard.com/ultimatebb.p...173#000000

speaks to Moog

Moog again:
http://natomessageboard.com/ultimatebb.p...974#000000


MM CC plates & prc
http://natomessageboard.com/ultimatebb.p...456#000000
Pete Dunham


Reply

vegas_ss Offline
Senior Member
#4
Thanks... I'm picking up the strut mounts from NAPA tomorrow... I asked them who made them and he said either dana or perfect circle, so I'll check them out. I was pretty sure the MM CC plates wouldn't work, but couldn't find the reference... Thanks again!
1987 TC, 5sp, Boport Stage 3 Head/2.1 Cam
1996 Impala SS, DCM, Borla Cat Back, too much other stuff!!! (SOLD)
2009 Pontiac G8 GXP 6M, 6.2l LS3, Kooks Long Tube, Hi Flo Cats, Mild Cam
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB