23027
Joined:
Aug 2007
South Surrey, British Columbia, Canada
|
|
So what would be the best substance to use in sticking my chrome T-Bird decal back on my tail light?
I tried to use 5-Minute Epoxy all it did was leave a sticky mess to clean up. Didn't hold at all. It was supposed to adhere to plastic surfaces too..
Thanks
|
BJL
Joined:
Apr 2001
Williamstown, New Jersey
|
|
try 3m double sided tape, it kinda like a thick foam tape, it meant for emblems and trim. it holds my body side moldings on my TC with no problems
Brian Larkin
88TC 330,000 miles
Slightly Modified
|
23027
Joined:
Aug 2007
South Surrey, British Columbia, Canada
|
|
Yeah the side moldings it will work good..
But it will stick out if I use that double sided tape..
Not good
|
Joe F
Joined:
Jul 2002
Hawkins, Texas - USA
|
|
They also make a very thin (almost like regular scotch tape) double sided product that works well if both surfaces are flat. I'm pretty sure 3M has it.
|
|
I stuck my Turbo Coupe emblems on the 3M double sided tape and traced around it with an exacto knife. After I pulled the excess tape off, I went around the whole thing with a sharpie so you couldn't see any white. Looks factory.
|
Beau
Joined:
Dec 2006
Lock Haven, PA
|
|
i used a very small amount of two part opoxy on my wifes car with good results.
Beau
-1988 Turbo coupe, 5 speed, Homemade boost controller, K&N cold air kit, By-pass-valve
-1988 mercury Cougar XR-7, 5.0
|
23027
Joined:
Aug 2007
South Surrey, British Columbia, Canada
|
|
Awesome.. I think i'll go with the double sided tape.
Very helpful.. Thanks boys
|