Please help wont turn over

Doing a 2.3 conv. on my 88 TBird.
I got the motor and tranny put in and wired to the point that it should start and it turned over. I then installed the fuel lines and after I tried to start and all I got was alot of clicking from the starter relay solenoid. Traced wires and the only thing I could find was the starter wire had gotten pushed against the tranny lines and there was a bare spot that would of grounded itself out. I fixed that wire and it still does it. I tried a new starter and different solenoids and didnt make a difference. The battery is fully charged and everything as I can tell after going over and over it id wired right. Nate

------------------
84 TurboCoupe conv. to H.O. w/3.73 and AOD
88 TBird w/5.0 converting to 2.3 Turbo and auto.

Did you check the fusible links, and did you try hot wiring the starter to see if it goes? Just a guess.

------------------
87 T/C, 5sp., Hardened Crank, Crower Sportsman Rods, J.E. full floating pistons, .030 over, Total Seal rings, Head and Main studs, Ported/Polished head, 1.89, 1.59 S.S Valves. Motorsport Lifters, A-234 cam, Fidanza Adj. cam sprocket, ported polished lower, gutted upper intake, Rod's S/S headers, 3" DP, T04B 57 Trim, custom Stage III, Gillis BCV, Forge Bypass, K&N Air Filter, Kirban Adj. FPR, Walbro 255 FP., 42# inj., J3 Adaptor. GN intercooler going in soon.