North American Turbocoupe Organization



Oil cooler hose size??? 5/8"???
fiveliter8 Offline
Senior Member
#1
Well, I checked all the local parts stores and none have these hoses available. I'm guessing I can have them dig through their 90 degree bent hoses and find a match, but am not sure of the size. I'm sure they are both the same (inlet and outlet) and was wondering what other part numbers you guys might have used to replace them. Thanks,

Alex

------------------
www.stangnut.com
1988 Tcoupe
1984 20th Anniversary GT350 Mustang 'Vert
1984 Mustang GT T-roof
1965 Shelby Cobra Replica
www.stangnut.com
1988Tcoupe-ye will be missed
'09 Flex SEL
1984 20th Anniversary GT350 Mustang 'Vert
1984 Mustang GT T-roof
1965 Shelby Cobra Replica
Reply

Hybridbird Offline
Posting Freak
#2
I just got some from advance.I dont have a part # but they were just 5/8 hoses with molded 90 bends in them,you need about 6 inches on either leg,maybe less.The ones you get will have much loger legs,usually only on one side but you can cut them to fit.

------------------
"Finch....get the f*ck away from that fikas......that is a jizz-free fikas!"
"Finch....get the f*ck away from that Ficus......that's a jizz-free Ficus!"
Reply

Pete D Offline
Administrator
#3
NAPA part #s 9807 and 7296. Between these 2 numbers you can replace every heater hose on the car except the smaller diameter one that goes to the lower intake. Cut to fit.
Pete Dunham


Reply

fiveliter8 Offline
Senior Member
#4
Man, I wish I could buy this forum a beer! [Image: smile.gif]
www.stangnut.com
1988Tcoupe-ye will be missed
'09 Flex SEL
1984 20th Anniversary GT350 Mustang 'Vert
1984 Mustang GT T-roof
1965 Shelby Cobra Replica
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB