I love it! If only mine had a chin to mount one to I would be doing this as well, unfortunately some previous owner cut the front of my lower bumper. Was it easy to mount?
1988 Turbo Coupe, Black/Black, 5 Speed, Moonroof, T3/T4, ported E6, 255LPH, Kirban, Stinger Exhaust, MGW shifter, K&N, Gillis valve, BP1.5, PIMPx, Koni's
1964 Ford Galaxie 500XL, 390 6V, Big Solid cam, Headers,3.89's, 4 Speed, Vast and fast
1960 Ford Starliner, 292 Y Block, 312 4bbl intake, headers, 3 Speed, slow and low
1988 T/C Silver with red interior, fully loaded except for leather. 5 lug conversion with 97 Cobra wheels, Cobra 13" brakes up front, Mustang brakes out back, Koni adjustable shocks and struts, NOS Koni lowering springs . Maximum Motorsports control arms and caster/camber plates, subframe connectors.
SOLD September 2020. Will miss this car after 19 years of building/driving/showing....time for a new chapter in my life.
You remove the flat factory one and this one mounts in its place and it does not effect the cooling.
1988 T/C Silver with red interior, fully loaded except for leather. 5 lug conversion with 97 Cobra wheels, Cobra 13" brakes up front, Mustang brakes out back, Koni adjustable shocks and struts, NOS Koni lowering springs . Maximum Motorsports control arms and caster/camber plates, subframe connectors.
SOLD September 2020. Will miss this car after 19 years of building/driving/showing....time for a new chapter in my life.
I ordered one from LMR and I love it. Drill it out to match the existing screw holes and use 3-4 of the supplied plastic push pin on each end (and yes, you'll cut off 3-4 inches from end). I found that making one relief cut on each side helps the corners align better. I don't know how someone figured out this fit but I love it. I added a picture of the '03-'04 Mach 1 for reference.
