North American Turbocoupe Organization



lower intake manifold?
w60 Offline
Senior Member
#1
I'm putting my head back on and when I took it off I left the intake manifold bolted to the head because removing the lower bolts looked like a losing proposition.

I would love to put the head on then the lower intake, but is it even possible to get to the lower bolts on the lower intake with it in position? If it is will you share the secret?
http://www.mycoachonline.com
White 88 TC Auto Trans
White 04 Honda CR/V
Blue 74 Honda Trail 70
Reply

Pete D Offline
Administrator
#2
It is possible but a bit of a PITA. Use a 1/4" drive setup set up instead of 3/8". You will need at least one flex coupling and a couple extensions. It's been a long time since, but I did it once.
Pete Dunham


Reply

jmthunderbirdturbo Offline
Posting Freak
#3
why? weight? i always bolt that on first. upper too, just not with the gasket (it will have to come back off to bolt the other stuff to the upper manifold, and to install the cam cover). then i use a 6 ft 2x4 and a chunk of rope and a friend, and we use the manifold to carry the head into the car, and set it down easy. saves your back, and avoids chinking the head on anything as you guide it in.

-J0N
APRIL 2018 - LOOKING FOR A NEW CAR. PM me if you have an 87-88 roller or cheap TF for sale.
1988 TC 5MT-Blue/Blue check-off car. resto-project.
2006 Honda Odyssey 5AT, baby-mobile.
2013 F-150, 5.0, 6AT, 4x4, snow white paint.
Reply

w60 Offline
Senior Member
#4
Genius Jon! I will give that a try on Wednesday when I hopefully get a few hours to work on it.
http://www.mycoachonline.com
White 88 TC Auto Trans
White 04 Honda CR/V
Blue 74 Honda Trail 70
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB