North American Turbocoupe Organization



Hood bolt question.....
Thndrchckn420 Offline
Senior Member
#1
Anyone know what size the hood bolts are? I misplaced mine sometime in the last 9 months while it was apart. Thanks
88 5-spd. Precision SC-50 ball bearing turbo, gillis, full 3" exhaust w/ 3- 1/2 crome tip, ported E-6, ported big exhaust valve head, ranger roller cam, Essy cam gear, K&N cone in front of the radiator, gutted upper, knife edged lower, Walbro 255HP pump, Kirban AFPR, Forge BPV, PA Performance 130 AMP Alt...
Reply

Thndrchckn420 Offline
Senior Member
#2
Bump... It IS hood not head. The bolts that hold the hood to the hinges. Anyone?
88 5-spd. Precision SC-50 ball bearing turbo, gillis, full 3" exhaust w/ 3- 1/2 crome tip, ported E-6, ported big exhaust valve head, ranger roller cam, Essy cam gear, K&N cone in front of the radiator, gutted upper, knife edged lower, Walbro 255HP pump, Kirban AFPR, Forge BPV, PA Performance 130 AMP Alt...
Reply

Pete D Offline
Administrator
#3
There is a number listed; N606689-S36, 16-25 lb.ft.
It does not give the size
Pete Dunham


Reply

Thndrchckn420 Offline
Senior Member
#4
Yeah, I found that. Guess Ill use the old trial and error method. Ill make sure I list it in the part #s section when I find it. Thanks
88 5-spd. Precision SC-50 ball bearing turbo, gillis, full 3" exhaust w/ 3- 1/2 crome tip, ported E-6, ported big exhaust valve head, ranger roller cam, Essy cam gear, K&N cone in front of the radiator, gutted upper, knife edged lower, Walbro 255HP pump, Kirban AFPR, Forge BPV, PA Performance 130 AMP Alt...
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB