North American Turbocoupe Organization



Head Gasket
bigep74 Offline
Junior Member
#1
Just curious any recommendations for a performance head Gasket? for around 24 pounds of boost
Reply

Jeff K Offline
Administrator
#2
Feloro 1035 is a good, but expensive HG, BUT the head and block surfaces MUST be perfectly flat for it to seal. Many have used the stock Felpro replacement at higher boost levels. Detonation from running too lean, too low octane fuel, or timing too advanced, not boost, is what blows head gaskets.
Jeff Korn

88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 24 psi, forced air IC, water injection, BPV, Ranger cam, subframes, etc., etc.
86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP N2O, ignition, gears, suspension, etc., etc.
05 Taurus SEL Duratec daily driver
04 Taurus Duratec (wifes car)
02 Pontiac Grand Prix GT
95 Taurus GL Vulcan winter beater
67 Honda 450 Super Sport - completely customized
Reply

bigep74 Offline
Junior Member
#3
I am looking at the Cometic Gasket C5369-027 - 0.027" MLS Head Gasket , and I am debating on studs ? or just standard Head bolts
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB