North American Turbocoupe Organization



exterior moulding
xcrunnerbd Offline
Posting Freak
#1
anyone heard any news about when aerobird motorsports is going to be up again? If not, does anyone know where I can get the moulding that goes around the car? I was hoping to buy the kit AM had .... would be a lot easier than cleaning and straightening my old moulding.

How about removing AM from the vendors and replacing it when /if it does come back?
Project 13 sec. / 30mpg in '88 TC 5Speed : 15.91@89mph / 32+ mpg

On The Car: KN cone, 2-stage Gillis@ 15psi wired to fuel switch, Kirban AFPR @ 39psi, Walbro 255 HP FP, 130A 3G Alt., Full 3" Stinger Exhaust incl. cat. no muffler,

Shelf: .48 T3, ported E6, BPV
Reply

turbot-bird Offline
Senior Member
#2
ya, I thought someone bought them out?
88TC undergoing transformation
Amsoil Dealer
NATO Vendor
My site
My Pictures
Reply

87TurboBobby Offline
Senior Member
#3
The moulding kit AM had was only the center of the side moulding. It came in the original red and other colors also. I bought one in red and it was close but not exactly like the original. Still have it, I didn't use it.
Bobby
90 Mustang GT Vert.
95 Mustang Vert
04 F150 Heritage
92 Chevy Silverado
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB