North American Turbocoupe Organization



Exhaust manifold bolts
w60 Offline
Senior Member
#1
In my eternal "20 minutes per day" head gasket replacement, I'm about to bolt the exhaust manifold back to the head.

The threads on the bolts just don't look pretty and I'm going to buy new bolts.

I looked at Rock Auto and Napa so far and can't find them in either place. They look like a standard bolt that should be easy to find but karma just isn't with me.

Where can I find new bolts and studs? The book says they are M10 1.5 x 57
http://www.mycoachonline.com
White 88 TC Auto Trans
White 04 Honda CR/V
Blue 74 Honda Trail 70
Reply

Pete D Offline
Administrator
#2
Behind door number 1: http://natomessageboard.com/ubbthreads.p...Post224466

Pete Dunham


Reply

w60 Offline
Senior Member
#3
"Thanks!" he said as he realized his pitiful attempt at searching on his own was, well...pitiful!
http://www.mycoachonline.com
White 88 TC Auto Trans
White 04 Honda CR/V
Blue 74 Honda Trail 70
Reply

Not B Anymore Offline
Administrator
#4
I've had that stud/nut combo on my '86 for 6 years and never had an issue with any of the nuts backing off. :thumbup:
Brian Leavitt
'86 TC 5-Speed -- MS2x w/COP | 83 lb. injectors | T3/T4 50 Trim Stage 3 .63AR | Full 3" Exhaust - No Cat | Motorsport FMIC | Ranger Roller | Ported E6 | Walbro 255HP | Kirban | 20psi | 120-amp 3G | 8.8" 3.55 rear | '03 Cobra Wheels
Reply

Ballman Offline
Senior Member
#5
Just go back to a Ford dealer , parts Dept. can find them . Just make sure you know the size needed . D.Wilder
DW
Reply

bigep74 Offline
Junior Member
#6
I actually found them at Lowes, I used stainless steel bolts with anti seize . The future will tell if this was a good idea......................
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB