North American Turbocoupe Organization



clutch options
phyxius Offline
Member
#1
what's a good clutch to use on a tc that will hold up to a min of 250rwhp.what clutch are u using or do u recomend
Reply

Pete D Offline
Administrator
#2
I'm using a Centerforce II in one car a nd a CF 1 in the other.

------------------
NATO Member. it's not a vice, it's an obsession
Good judgement comes from bad experience, and a lot of that comes from bad judgment.
88 TC X 2, 86 SVO, mods list at
http://www.turbotbird.com/showroom/pd_88tc.htm
Pete Dunham


Reply

phyxius Offline
Member
#3
and which do u prefer out of the two,and just out of curiosity how much were they
Reply

Glenn 88TC Offline
Posting Freak
#4
I would recommend the Star clutch. You can get 4 different stages to meet you car performance capablities. Check the vendors section for S&R Racing. They have the star clutches listed. Scott is a TC owner and has the stage 3 as do I. I think this is the best clutch I ever had in this car.

------------------
Glenn 88TC
current mods: ported & polished big valve head(1.89/1.59), ranger roller, custom upper and ported lower intakes, t3/t4 turbo, powerstroke intercooler mounted full size, 60mm throttle body, R.C. Engineering 42lb. injectors, MSD 6al, MSD Launch Control, MSD 8.5mm wires, K&N filter, Walboro 255HP pump, Kirban adj. fuel reg., ATR header, full 3" exhaust with Dynomax Ultraflow muffler, Star stage III clutch, Hallman boost controller, Flex-a-lite adj. temp switch for stock fans, Weld Draglites with M/T ET Street 26x11.5/15

87 Merkur Xr4ti - daily driver
NO TC and NO headaches.
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB