North American Turbocoupe Organization

Carlisle Demo?
fred k Offline
Senior Member
Since I live close enough to Carlisle I'd be willing to bring an intake and exhaust manifold and possibly a head from my 87 TC to the show for the purpose of one of our elder statesman to point out the porting nuances we read so much about. If said elder statesman were to volunteer to host the demo he could possibly throw his porting tools (bits etc.) in his trunk for our viewing pleasure. Any volunteers????????? [Image: biggrin.gif]
fred l kennedy

Pete D Offline
I'd be glad to bring a sample of the tools I use. If I get real lucky I might bring some finished samples. In 2000, Dave Godfrey brought a cut up head and gave a talk on porting the 2.3. I'm going to try to find out if he might do it again. He is the expert.

NATO Member
88 TC X 2, 86 SVO, Main TC with K&N, 3"DP to 2.5"duals through Dynamax, Ric valve at 17+ and disconnected KS. Elite Bodega 16" chrome wheels. Autometer pod w/ A/F and Vac/boost gauges.140 mph Motorsports Speedo New engine: Total Seal rings and TRW pistons, ported and polished head w/ cc'd chambers,1.59"exhausts, SS valves, gutted upper, knife edged lower, A-230 cam, Race Engineering Adj Cam Sprocket, Crowlers, ARP head studs, and rod bolts. Walbro 255 HP pump and Kirban adj FPR, T-3. Centerforce II, KB subs and jack rails.
Pete Dunham


Blade1433 Offline
Senior Member
And I'll be happy to display my po-man's direct port nitrous thingy


"Drive it like you stole it"

88 bone stock TC with 138k, 5spd, burgundy, almost all options with new U-joints, tranny Xmember, front end, FULL tune-up with select MSD products, new horizontal axle shock thingies, custom interior, white face guages. Coming soon: boost guage and air fuel ratio guage on the pillar, Gillis valve, K&N, gutted upper, knife edged lower, gutted E6, T3, and steam cleaned engine bay.

Users browsing this thread:
1 Guest(s)

Theme © iAndrew 2018 - Software MyBB