North American Turbocoupe Organization



Bracks
Harvs Offline
Senior Member
#1
I need parts for my back brakes is anyone from the mass area that knows where I could get parts like the clips to hold the pads on or rubber boots, thanks.

[This message has been edited by Harvs (edited 08-03-2002).]
Sandlewood beige 88 coupe 93k/ super 60 T3 at 24 pounds/ ATR 3" no cat or tail pipe/ 255lph high pressure pump/ Kirban AFPR at 42/ Spec stg3/ GN FMIC/ 1g DSM BOV/ 14* timing/ disconected KS/ Tri-ax short throw/ Autometer boost,vac and air to fuel/ 140 spedo/ Ford motorsports 5300-c springs/ tubular rear upper cntrl arms.
Reply

Jeff K Offline
Administrator
#2
By clips do you mean the antirattle clips that the pads fit into? By rubber boots, do you mean the boots that keep water out of the slider pins? If so, any big parts store should have them. I bought 2 caliper repair kits that had new boots, slider pins, bolts, and antirattle clips, etc. for about $10 each at Auto Zone about a year ago.

------------------
Jeff Korn

88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 20 psi, forced air intercooler, water injection, bypass valve, Ranger roller cam, subframes, etc., etc.. // 86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP nitrous, ignition, gears, suspension, etc., etc.... // 91 Escort: Bone stock winter car // 00 Windstar (wifes vehicle)
Jeff Korn

88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 24 psi, forced air IC, water injection, BPV, Ranger cam, subframes, etc., etc.
86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP N2O, ignition, gears, suspension, etc., etc.
11 Crown Vic Interceptor
14 Toyota Camry (wifes car)
95 Taurus GL Vulcan winter beater
67 Honda 450 Super Sport - completely customized
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB