North American Turbocoupe Organization



Aux Shaft?
w60 Offline
Senior Member
#1
ok, trying to pull the aux shaft because I think I can find the bolt I dropped down the oil return passage thru the hole where the aux shaft is and because it looks easy.

When I pull it out, it gets as far as the bearing and the warnings say don't let it touch the bearing.

I'm assuming I have to remove and replace that bearing or am I missing something?
http://www.mycoachonline.com
White 88 TC Auto Trans
White 04 Honda CR/V
Blue 74 Honda Trail 70
Reply

Jeff K Offline
Administrator
#2
I assume you have the distributor out already?

No need to replace the aux shaft bearings if they are in good shape. Just dont scratch them while pulling the shaft out.
Jeff Korn

88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 24 psi, forced air IC, water injection, BPV, Ranger cam, subframes, etc., etc.
86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP N2O, ignition, gears, suspension, etc., etc.
11 Crown Vic Interceptor
14 Toyota Camry (wifes car)
95 Taurus GL Vulcan winter beater
67 Honda 450 Super Sport - completely customized
Reply

w60 Offline
Senior Member
#3
yes...distributor is out and thanks!

Sometimes I just don't know how hard to pull and the book reads like if anything touches the bearing you have 3,400 pounds of scrap sheet metal.
http://www.mycoachonline.com
White 88 TC Auto Trans
White 04 Honda CR/V
Blue 74 Honda Trail 70
Reply

w60 Offline
Senior Member
#4
Aux shaft out, found the bolt I dropped, got it out and now I'm buttoning up on the self inflicted damage. When that is done the head goes back on.

Thanks for the guidance!
http://www.mycoachonline.com
White 88 TC Auto Trans
White 04 Honda CR/V
Blue 74 Honda Trail 70
Reply

Pete D Offline
Administrator
#5
Glad to here the tide shifted in your favor.
Pete Dunham


Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB