North American Turbocoupe Organization



Auto TO T-5 swap
bizkit24737 Offline
Junior Member
#1
I traded 4 a 88 TC it has a auto thats gone bad ,i have all the stuff to make it a 5 speed ,,but what bugs me is if i do the swap will my firm ride still work ???this is my first TC ,don't know much about them , allways played my 5.0s ,,,thanks
Reply

Pete D Offline
Administrator
#2
The trans swap will not have any affect on the PRC system. If it works now it should work after the swap as long as you hook up the VSS wiring to the manual trans.

------------------
NATO Member. it's not a vice, it's an obsession
"The nice thing about each new day is nobody ever used it before" Barnaby Jones
88 TC X 2, 86 SVO, mods list at
http://www.turbotbird.com/showroom/pd_88tc.htm
Pete Dunham


Reply

87tc Offline
Junior Member
#3
im going to do this same swap i have a 5 speed from an earlier tc (mine is a 87) the trans i have is setup for cable acuated clutch assembly what else do i need and how involved is installing the pedal assembly (i hope i dont have to pull the dash again i just did the heater core..)i assume i need the later bellhousing pedals slave and master fly wheel clutch etc is the hole in the floor in the same spot?? will i need a different crossmember or mount is the speed sensor from an earlier tranny the same?? can i use the onefrom the auto if they are not??? is the drive shaft the same??? any help from someone who has done this swap would be greatly appreciated ....
Reply

cobra_steven Offline
Junior Member
#4
In order for you to convert you gotta basically have the stuff from a 87 or 88...these both have/use Hydraulic clutches...you need the lil resivor (!?) thing that holds the fluid...a bell housing that holds that hydraulic piece...of course the petals...you gotta take out the break and get both Break-N-Clutch together....Took me a while to get those in and outta there...you do need a diff drive shaft..the auto has a big ole circular thing on it...and i could be wrong but i think they're diff lenghts?? As for the wires...I have no clue cause mine's all ghetto rigged... hope this helped somewhat...
Reply

87tc Offline
Junior Member
#5
[This message has been edited by 87tc (edited 12-12-2002).]
Reply

TurboE Offline
Posting Freak
#6
Use the search, i wrote up very detailed stuff about the swap i did it about 3 months ago. I believe you need the tbird manual tranny driveshaft, you dont need to pull the dash, but pull the drivers side seat out. The hole in the floor is in the correct spot, but needs to be opened up slightly, not very critical the cut from the factory was not very impressive to me. SEARCH and you will find lots of info check the dates the posts i did were anytime from september 2002 to now. After you read enough then ask specific questions before the fun part, doing the work.
-88 TC Black
5spd, Precision SC50 T3/T4, QH/SD Tune, Gillis, AFPR, 255FP, WB O2, K&N, Ported E6, 3" DP, ATR 2.5" Duals, 3:73 Rear, Konis, Eibachs, 18" Voxx Wheels, X Drilled Rotors.
-06 G35 Coupe Diamond Graphite
-97 Pathfinder
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB