Anybody Going To The Keystone Natl. Brian Bitters?

Anybody planning on going to the Keystone Natls. this weekend at Maple Grove in Reading, Pa. If so what day? Also, does anyone know if Brian Bitters is planning on running there this weekend (what day if so)?

I don't know if he will be running at that event, but I am trying ti get him to race at Cecil county dragway in MD. on the 21st(Fri.) of Sept. I emailed him to ask if he is running the Nationals. If I here anything I will let everyone know.

------------------
Glenn 88TC
current mods (14.096 at 97.29mph): ported & polished big valve head(1.89/1.59), ranger roller, gutted upper and ported lower intakes, t3/t4 turbo, MSD 6al, MSD Launch Control, K&N filter, Walboro 255 pump, Kirban adj. fuel reg., ATR header, full 3" exhaust with Dynomax Ultraflow muffler, Star stage III ceramic clutch, Tiny Avenger bleed valve

Mods in progress (have, just not on yet): 65mm throttle body, 42lb. injectors, Taylor pro wires, 4.10 gears, Spearco intercooler, Nitrous system

The Keystone Nationals were post poned I think until the Oct. 4th weekend. Either way Brian Bitters will not be running. He is having soem tuning problems and doesn't have the car up to potential, yet. I will be running at Cecil County drag way in MD on Fri. the 21st and either the 4th or 5th of Oct.(Fri. Sat. nights). I would like to see some other TC's there for a change. Brian might be there for this, but his car might not be ready by then. I am trying to get him to race before the end of the season. His last run at Maple Grove resulted in a 6 second 60' time(yes 6seconds, the car almost cut out on him) and the remainder of the track took 11 seconds. He ended up with a 17.3 at 119mph. That mph is good for mid to low 11's.

------------------
Glenn 88TC
current mods (14.096 at 97.29mph): ported & polished big valve head(1.89/1.59), ranger roller, gutted upper and ported lower intakes, t3/t4 turbo, MSD 6al, MSD Launch Control, K&N filter, Walboro 255 pump, Kirban adj. fuel reg., ATR header, full 3" exhaust with Dynomax Ultraflow muffler, Star stage III ceramic clutch, Tiny Avenger bleed valve

Mods in progress (have, just not on yet): 65mm throttle body, 42lb. injectors, Taylor pro wires, 4.10 gears, Spearco intercooler, Nitrous system