North American Turbocoupe Organization



All I can say is WOW!!!
Glenn 88TC Offline
Posting Freak
#1
As many of you know I have had issues with the car since the powerstroke intercooler and big t3/t4 install. I worked out all the bugs last fall but never drove the car with boost control till this week. Imagine how hard it is to drive the car and not be able to get into boost because the boost isn't limited. The car runs too rich from the big injectors so I can only imagine how much better the car will run when the SDS goes on later this spring. Today I watched the tach after I jumped on the gas in first gear to see what kind of response I get. The tach hits 2000 then 2500 and no boost. Starts creeping past 2800 and it finally starts to build boost. Tach hits 3000rpms with about 3psi and then just explodes to 18psi. The car loses all traction and spun so bad it almost seemed to slow down a little. All I can say is once boost hits it is very violent. I go from no boost to max boost from 2800 to 3000rpms. Now I just need the SDS, Engle 111 cam and the 73pph injectors. Hopefully I will have it done by Carlisle.

------------------
Glenn 88TC
current mods: ported & polished big valve head(1.89/1.59), ranger roller, custom upper and ported lower intakes, t3/t4 turbo, powerstroke intercooler mounted full size, 60mm throttle body, R.C. Engineering 42lb. injectors, MSD 6al, MSD Launch Control, MSD 8.5mm wires, K&N filter, Walboro 255HP pump, Kirban adj. fuel reg., ATR header, full 3" exhaust with Dynomax Ultraflow muffler, Star stage III clutch, Hallman boost controller, Flex-a-lite adj. temp switch for stock fans, Weld Draglites with M/T ET Street 26x11.5/15

87 Merkur Xr4ti - daily driver
NO TC and NO headaches.
Reply

Pete D Offline
Administrator
#2
Sounds awesome Glenn. Can't wait to see it on the dyno

------------------
NATO Member. it's not a vice, it's an obsession
Good judgement comes from bad experience, and a lot of that comes from bad judgment.
88 TC X 2, 86 SVO, mods list at
http://www.turbotbird.com/showroom/pd_88tc.htm
Pete Dunham


Reply

Harvs Offline
Senior Member
#3
Glenn, sounds sweet, hope to have my car spinning the tires when boost comes on, have fun!

[This message has been edited by Harvs (edited 03-20-2003).]
Sandlewood beige 88 coupe 93k/ super 60 T3 at 24 pounds/ ATR 3" no cat or tail pipe/ 255lph high pressure pump/ Kirban AFPR at 42/ Spec stg3/ GN FMIC/ 1g DSM BOV/ 14* timing/ disconected KS/ Tri-ax short throw/ Autometer boost,vac and air to fuel/ 140 spedo/ Ford motorsports 5300-c springs/ tubular rear upper cntrl arms.
Reply

oldraven Offline
Senior Member
#4
mmmmmm. words of encouragement. Thanks for sharing. I'm going to write down your mods now. Sounds like you've got what I need.

------------------
I'd like to think my life has a soundtrack, and it sounds just like the white album.

1987 Turbo Coupe, 5-spd. Burgundy, k&n drop in, 3" d.p., 2.5" duals. Going into hibernation.

http://www.cardomain.com/id/oldraven

CAW!!
I'd like to think my life has a soundtrack, and it sounds just like the white album.

1987 Turbo Coupe, 5-spd. Candy Apple Red w/ Charcoal Smoke Accents, k&n drop in, 2.5" duals. Stirring from her winter slumber.

http://www.cardomain.com/id/oldraven

http://www.cardomain.com/id/doasa
http://www.cardomain.com/id/jeepishltd

CAW!!
Reply

Glenn 88TC Offline
Posting Freak
#5
I've had my car spin the tires from just the boost hitting ebfore, but never like this. The boost hits, the car goes sideways and it hits the limiter. It happens very quick. First gear is almost too quick now. I couldn't imagine having lower gears.

------------------
Glenn 88TC
current mods: ported & polished big valve head(1.89/1.59), ranger roller, custom upper and ported lower intakes, t3/t4 turbo, powerstroke intercooler mounted full size, 60mm throttle body, R.C. Engineering 42lb. injectors, MSD 6al, MSD Launch Control, MSD 8.5mm wires, K&N filter, Walboro 255HP pump, Kirban adj. fuel reg., ATR header, full 3" exhaust with Dynomax Ultraflow muffler, Star stage III clutch, Hallman boost controller, Flex-a-lite adj. temp switch for stock fans, Weld Draglites with M/T ET Street 26x11.5/15

87 Merkur Xr4ti - daily driver
NO TC and NO headaches.
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB