AC Wiring Diagram???

I am in desperate need of anything to do with the AC electrical system... any wiring diagrams/schematics, etc. Can someone help?

Thanks

I have the electronic climate control module... I need any info available. Thanks again.

Check your email

Thank you Pete... you've made a very discouraged person a little less discouraged

What's the specific problem?

The clutch is not engaging with the AC on on the panel. There's enough charge in the system for clutch operation. No voltage at the low pressure connector (by the firewall) and no ground either. Found a ground at the high pressure connector. Put voltage to the high press connector and I hear a relay click in the IRCM. Appears as if all fuses are OK, checked them at both sides with a test light. I'm not sure if the panel is acting up, if a switch is out, if the relay is messed up.. just looking for something to troubleshoot the system. I did a lot of crap shooting so far.

??????????????????

I had issues with the IRCM. The oiginal went bad and the first replacement was bad out of the box, both with the same problem... no a/c.
I could get both of them to switch on and off when I pushed/pulled/twisted the connector going into the IRCM. Try pushing it to the left/right and see if the compressor kicks on. Must have been bad connections inside.

1. I've had the pressure switch go mostly bad. It would work sometimes but not consistently.

2. I had the power electronics that drives the compressor go bad. It is an aluminum heat sink piece that goes into the side of the heater box in the dash. I found a Mark VII in the jy that used the same parts and swapped it out. The one I pulled out of my car had some serious corrosion issues.

steve

I can't find that heat sink piece... I found something with a white plug connector attached to the inside of the fender.. is that it?

Called the blower motor speed controller, it's attached to the center of the evaporator case right under the blend door actuator. It controls the blower and supplies power to the A/C pressure switch. Look for a black six wire connector plugged into the case. The heat sink is inside the case so the air blowing through will cool it off.