North American Turbocoupe Organization



90 degree elbos?
Harvs Offline
Senior Member
#1
I searched, but no answer. Where can i get 2.5 inch 90 degree radiator hose? For intercooler piping
Sandlewood beige 88 coupe 93k/ super 60 T3 at 24 pounds/ ATR 3" no cat or tail pipe/ 255lph high pressure pump/ Kirban AFPR at 42/ Spec stg3/ GN FMIC/ 1g DSM BOV/ 14* timing/ disconected KS/ Tri-ax short throw/ Autometer boost,vac and air to fuel/ 140 spedo/ Ford motorsports 5300-c springs/ tubular rear upper cntrl arms.
Reply

Glenn 88TC Offline
Posting Freak
#2
Any major turbo shop should have them. I would recommend silicone hoses also. Much more durable.

Innovative turbo(bought mine there)
Turbonetics
Precision Turbo



------------------
mods: SDS Digital Fuel Injection, ported & polished big valve head(1.89/1.59), Solid lifters, Esslinger roller cam #2277, Esslinger adj. cam pulley, custom upper and ported lower intakes, 60-1 stage III .63 turbo, powerstroke intercooler, 60mm throttle body, 75pph injectors, Walboro 255HP pump, Kirban adj. fuel reg., ATR header, 3" exhaust with Dynomax Ultraflow muffler, MSD 6al, MSD coil, MSD Launch Control, MSD 8.5mm wires, K&N filter, Spec stage III clutch, Greddy Profec B boost controller, Weld Draglites with M/T ET Street 26x11.5/15
NO TC and NO headaches.
Reply

SteveX82 Offline
Posting Freak
#3
When I was searching for parts for my fmic setup, I first looked into silicone elbows, too....but after seeing them going for $30-$40 APEICE, I quickly realized I needed to come up with a cheaper idea. If you've got the room, consider using mandrel bent 90º elbows from jcwhitney. They're about $11 apeice, but that'll still save you a bit of money when you consider you'll probably need at least 6-8 bends. The piping also has a much more gradual bend to it, which I'd imagine might flow a bit better.

I also had a link to an online truck shop that sold rubber hose bends, but I can't find it at the moment. I recall them being about $10 apeice at most for the 2.5" bends.

------------------
Estoril blue 1987 TC 5spd, 146k miles, a237, Bailey BOV, rod's header, spec stg3 clutch, spearco FMIC, t3/t4 50 trim / stage III .63, 3" exhaust, eec-tuner, lm1 wb, 55pph injectors
Best 1/4 mile: 12.89 @ 106mph on 25psi, 1.78 60'
Estoril blue 1987 TC 5spd, 148k mi, a237, Bailey BOV, spec stg3 clutch, spearco FMIC, 50 trim t3/t4, 3" exhaust, Bamafuel, LM1, 55pph
Best 1/4 mile: 12.31 @ 110mph on 25psi
Reply

Reeve Offline
Member
#4
Look on ebay. They have all kinds of bends and reducers.
1988 TC stock for now
1980 Capri RS turbo [email protected] broken
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB