| #1 |
I am posting this for a friend that runs an Engine Machining Service local to me. Please contact him, not me. Contact info below.
-------------------------------------------------------------
For Sale 1988 Turbo Coupe 2.3L Engine Parts
Contact Rich at 440-986-6111 Prices negotiable.
Some Parts were machined at seller's machine shop. Parts were never picked up by purchaser. Parts are located in Lorain County, northern Ohio. Shipping available at buyers expense.
2 - Engine blocks:
Block #1 was machined elsewhere and brought to seller for hot tanking and bore measurement which determined block had been overbored past 0.030 up to 0.032" and out of round. No further work done to it. Could be used to for a beater but not good bet for the long run. Bare block only.
Price: $50 as is, where is.
Block #2: Hot tanked, bored and honed 0.020" over, decked, aligned hone crank mains, chase threads on mains. Work done by Rich, a professional engine builder. Bare block only. Has main studs. New aux shaft bearings. Price $500
1 - Crankshaft:
hot tank crank
Turn crank 10/10 under
Balance Crank
Price: $250
1 - Cylinder Head:
Remove valves and magnaflux seats. No cracks found. This is a turbo D port head. No other work done. $250
-------------------------------------------------------------
For Sale 1988 Turbo Coupe 2.3L Engine Parts
Contact Rich at 440-986-6111 Prices negotiable.
Some Parts were machined at seller's machine shop. Parts were never picked up by purchaser. Parts are located in Lorain County, northern Ohio. Shipping available at buyers expense.
2 - Engine blocks:
Block #1 was machined elsewhere and brought to seller for hot tanking and bore measurement which determined block had been overbored past 0.030 up to 0.032" and out of round. No further work done to it. Could be used to for a beater but not good bet for the long run. Bare block only.
Price: $50 as is, where is.
Block #2: Hot tanked, bored and honed 0.020" over, decked, aligned hone crank mains, chase threads on mains. Work done by Rich, a professional engine builder. Bare block only. Has main studs. New aux shaft bearings. Price $500
1 - Crankshaft:
hot tank crank
Turn crank 10/10 under
Balance Crank
Price: $250
1 - Cylinder Head:
Remove valves and magnaflux seats. No cracks found. This is a turbo D port head. No other work done. $250
Pete Dunham