16mm T-3 turbo water jacket fittings

I recently installed a rebuilt t-03 turbo from a TC in my Dodge Neon. Please no flames for the non TC post. Any info regarding what year TC this turbo was installed on or where I might find these fittings would be much appreciated. The measurement at the bearing housing is 16mm for the water jacket inlet.
Thanx,
Mel

The T-3s were installed on the 83-86 TCs. 87-88 used an IHI turbo. Probably any turbo shop could get the fittings. I got fittings at a hardware store that kind of carries everything. Look in the phone book or the back of performance mags for turbo shops.

------------------
88 TC X 2, 86 SVO, Main TC with K&N, 3"DP to 2.5"duals through Dynamax, Ric valve at 17+ and disconnected KS.
Elite Bodega 16" chrome wheels. Autometer pod w/ A/F and Vac/boost gauges.140 mph Motorsports Speedo New engine: Total Seal rings and TRW pistons, ported and polished head w/ cc'd chambers,1.59"exhausts, SS valves, gutted upper, knife edged lower, A-230 cam, Race Engineering Adj Cam Sprocket, Crowlers, ARP head studs, and rod bolts. Walbro 255 HP pump and Kirban adj FPR, T-3. Centerforce II, KB subs and jack rails.

The water jacket fittings arent anything special... just standard NPT pipe fittings. I forget exactly what size, but I think they are 5/16 NPT. When I switched the turbo on my 88 TC from an IHI to a T3, I just got fittings from the local hardware store.

------------------
Jeff Korn

88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 20 psi, forced air intercooler, water injection, bypass valve, Ranger roller cam, subframes, etc., etc.. // 86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP nitrous, ignition, gears, suspension, etc., etc.... // 91 Escort: Bone stock winter car // 00 Windstar (wifes vehicle)