North American Turbocoupe Organization



Looking for a diagram of all sensor locations
Cullen Offline
Member
#1
I am completely starting from scratch on installing a 2.3 turbo from a 1987 turbo coupe. I am not sure where all the sensors are or even what they look like. So I am looking for a diagram that shows the location and names each sensor, solenoid etc. 

This is my first experience with an SVO. It is not my first experience in totally rewriting engines in cars. It is my first experience with a turbo.
Any help would be greatly appreciated.

I would also like a diagram that shows where all of the vacuum lines run on the SVO 2.3 turbo.
brokenbirdy likes this post
Reply

Cullen Offline
Member
#2
Wow, I have not been referred to as “Junior” for 65 years. It makes me feel young all of a sudden.
LOL
brokenbirdy likes this post
Reply

Mikey97D Offline
Senior Member
#3
Andrew has been converting all the files to the Tech Articles section: https://turbotbird.com/forum-tech-articles

From the old website here's the engine bay: https://turbotbird.com/old/faqs/engine.jpg

Here's the vacuum line layout: https://turbotbird.com/old/faqs/Vac_Diagram.htm

And a wiring diagram: https://turbotbird.com/old/technical_art..._Rev_1.pdf

I suggest saving those diagrams since they may not all make the conversion if they haven't already.
1988 TC, 5 spd, Stinger 3" Exhaust, Schneider Roller Cam, -4° Cam Pulley, Cone Filter, Gilles Boost Control Valve set at 17 psi, Walbro 255 lph, CHE Rear Lower and Upper Control Arms, Braided Brake Lines, Hawk HPS 5.0 Front and HPS (F) Rear, CRES Inserts in front calipers, and '93 Cobra Wheels with General 235/50R17 Tires.   
Reply

Cullen Offline
Member
#4
Thank you sir.
Reply

Cullen Offline
Member
#5
wow these are just what I needed. I was close to most things but these diagrams open up more understanding. Thanks so much.
Mikey97D likes this post
Reply





Users browsing this thread:
1 Guest(s)



Theme © iAndrew 2018 - Software MyBB