rich
Joined:
Dec 2002
tampa, FL USA
|
|
I was trying to take the tranny line out at the tranny side, and the brass nut snapped, leaving the threaded portion in the trans. Not enough thread sticking out to get a hold of. What should I do now?? I just have no luck with these cars at all.
2.3L Turbo in 88 stang, browntops, 93 a4ld, volvo ic, broncoII rad, gillis valve set @15, k&n af.
|
Jeff K
Joined:
Apr 2001
Milwaukee, WI
|
|
If the A4LD is like the AOD (not sure), the fitting doesnt come off, you use a special tool to remove the line from the fitting. Anyone know for sure??
------------------
Jeff Korn
88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 20 psi, forced air intercooler, water injection, bypass valve, Ranger roller cam, subframes, etc., etc.. // 86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP nitrous, ignition, gears, suspension, etc., etc.... // 91 Escort: Bone stock winter car // 02 Taurus Vulcan(wifes car)
Jeff Korn
88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 24 psi, forced air IC, water injection, BPV, Ranger cam, subframes, etc., etc.
86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP N2O, ignition, gears, suspension, etc., etc.
11 Crown Vic Interceptor
14 Toyota Camry (wifes car)
95 Taurus GL Vulcan winter beater
67 Honda 450 Super Sport - completely customized
|
Hawk
Joined:
Sep 2002
Monroe, Oregon USA
|
|
Yes, they use the fuel line/AC line type tool to release the line from the fitting. The fitting/coupling is threaded into the trans housing. You are going to have to be real careful about getting any chips inside the trans when you try to remove the broken off section.
Hawk
|
mjbtbrd
Joined:
Dec 2002
Boston MA
|
|
use a screw/bolt extractor it is essentally a left hand thread self tapping self threading screw it shoulkd allow you to wind out the broken off piece had something similar happen to me. on a AOD
you can get a new fitting from ford also and some places that cater to tranny people will have them too ford number i got was
E1DZ-7D273-A
for my aod but i think they are all alike
|
rich
Joined:
Dec 2002
tampa, FL USA
|
|
Thanks. I'll try to get the tool and see if I can back it out.
Maybe I should just do a t5 swap.
2.3L Turbo in 88 stang, browntops, 93 a4ld, volvo ic, broncoII rad, gillis valve set @15, k&n af.
|
rich
Joined:
Dec 2002
tampa, FL USA
|
|
Just wanted to let you guys know I appreciate the help. Got the fitting out with a screw extractor, replaced the fitting, and all is well.
2.3L Turbo in 88 stang, browntops, 93 a4ld, volvo ic, broncoII rad, gillis valve set @15, k&n af.
|
philS
Joined:
Apr 2001
Bellingham, MA
|
|
Good deal!
------------------
86 TC, 73 Austin Mini, 72 Austin Mini Van
Click here to beat a ricer.
Did you hear about the Lucas powered torpedo? It sank.
86 TC, 73 Mini, 64 Mini Van, Saturn wagon
Click here to beat a ricer.
|
|