12-04-2002, 09:01 PM
12-04-2002, 09:11 PM
This is a picture of SteveX2's installation
------------------
NATO Member. it's not a vice, it's an obsession
"The nice thing about each new day is nobody ever used it before" Barnaby Jones
88 TC X 2, 86 SVO, mods list at
http://www.turbotbird.com/showroom/pd_88tc.htm
------------------
NATO Member. it's not a vice, it's an obsession
"The nice thing about each new day is nobody ever used it before" Barnaby Jones
88 TC X 2, 86 SVO, mods list at
http://www.turbotbird.com/showroom/pd_88tc.htm
12-04-2002, 10:21 PM
I'm so flattered [Image: smile.gif]
I'd like to point out that I have since reversed the direction of my BPV. I am now using the side port as the input end and the bottom port as the output end. After visually inspecting the insides of the BPV, I decided that using it in that direction would enable the valve to hold the most boost without leaking.
I'd like to point out that I have since reversed the direction of my BPV. I am now using the side port as the input end and the bottom port as the output end. After visually inspecting the insides of the BPV, I decided that using it in that direction would enable the valve to hold the most boost without leaking.
12-04-2002, 10:39 PM
Quote:Originally posted by SteveX82:
I'm so flattered [Image: smile.gif]
I'd like to point out that I have since reversed the direction of my BPV. I am now using the side port as the input end and the bottom port as the output end. After visually inspecting the insides of the BPV, I decided that using it in that direction would enable the valve to hold the most boost without leaking.
I have mine hooked up "reversed" from your pic (the way you have yours hooked up now... side in / end out), and it holds 21 psi no problem.
------------------
Jeff Korn
88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 20 psi, forced air intercooler, water injection, bypass valve, Ranger roller cam, subframes, etc., etc.. // 86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP nitrous, ignition, gears, suspension, etc., etc.... // 91 Escort: Bone stock winter car // 00 Windstar (wifes vehicle)
12-05-2002, 12:27 AM
Jeff, Do you have a picture of yours?
12-05-2002, 06:58 PM
Quote:Originally posted by miamihawk:
Jeff, Do you have a picture of yours?
Not a good close up pic, but my install looks almost the same as Steves... I just tapped into the IC tank several inches farther back (toward the firewall) than Steve did. My install was a bit tighter than Steves, as I still have functioning A/C.
------------------
Jeff Korn
88 Turbo Coupe: Intake and exhaust mods, T3 turbo at 20 psi, forced air intercooler, water injection, bypass valve, Ranger roller cam, subframes, etc., etc.. // 86 Tbird 5.0 (original owner): intake, exhaust, valvetrain mods, 100 HP nitrous, ignition, gears, suspension, etc., etc.... // 91 Escort: Bone stock winter car // 00 Windstar (wifes vehicle)