07-16-2010, 06:48 PM
I haven't been online as much as I used to be, and I certainly haven't posted anything having to do with my car, but that doesn't mean I haven't been sneaking in some work sessions as time allows.
I plan to have the car ready for Englishtown's Road Course by August 13th, so I can try to run a few break-in laps.
Here's what's done-
12" K&N cone
60-1 equiv. "holset hybrid" turbo
FMIC w/ modified DSM Gen1 BPV
Ranger Radiator w/custom shroud and slim fan
65mm Throttle Body
Custom tubular upper intake/ ported lower
Lightly ported rebuilt head
BoPort 1.9 cam w/ adj cam gear
Stinger header w/spacer, oil feed, oil drain
38mm External Wastegate (freebie from a friend!)
Looped cooling hoses w/new feed to oil "cooler"
46pph Injectors
Steeda Tri-ax (Stinger's wasn't available then)
I still have a LOT to do before August though. The suspension is going to get "freshened up" with goodies from Maximum Motorsports. The brakes will be redone with EBC pads/rotors. The clutch and flywheel will be replaced with bits from Spec and Fidanza, with ARP hardware. Chuck's Motor Mounts are waiting next to the lightweight starter. The new seats/harnesses will be mounted. The Downpipe needs redone to match Stinger's header and I'll need to run the flex-pipe for the wastegate dump. I'm sure I'm forgetting something here, but it kills to me to see all this stuff just sitting, while I don't have enough time to install it all right now.
http://natomessageboard.com/uploads/0000...C_0097.jpg
http://natomessageboard.com/uploads/0000...C_0098.jpg
http://natomessageboard.com/uploads/0000...C_0099.jpg
I hope the pictures load up properly.
-Nate
I plan to have the car ready for Englishtown's Road Course by August 13th, so I can try to run a few break-in laps.
Here's what's done-
12" K&N cone
60-1 equiv. "holset hybrid" turbo
FMIC w/ modified DSM Gen1 BPV
Ranger Radiator w/custom shroud and slim fan
65mm Throttle Body
Custom tubular upper intake/ ported lower
Lightly ported rebuilt head
BoPort 1.9 cam w/ adj cam gear
Stinger header w/spacer, oil feed, oil drain
38mm External Wastegate (freebie from a friend!)
Looped cooling hoses w/new feed to oil "cooler"
46pph Injectors
Steeda Tri-ax (Stinger's wasn't available then)
I still have a LOT to do before August though. The suspension is going to get "freshened up" with goodies from Maximum Motorsports. The brakes will be redone with EBC pads/rotors. The clutch and flywheel will be replaced with bits from Spec and Fidanza, with ARP hardware. Chuck's Motor Mounts are waiting next to the lightweight starter. The new seats/harnesses will be mounted. The Downpipe needs redone to match Stinger's header and I'll need to run the flex-pipe for the wastegate dump. I'm sure I'm forgetting something here, but it kills to me to see all this stuff just sitting, while I don't have enough time to install it all right now.
http://natomessageboard.com/uploads/0000...C_0097.jpg
http://natomessageboard.com/uploads/0000...C_0098.jpg
http://natomessageboard.com/uploads/0000...C_0099.jpg
I hope the pictures load up properly.
-Nate