North American Turbocoupe Organization

Full Version: Getting old quick
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
Pages: 1 2
I put the holeset in and now the bird wont start. ran before and I'm running out of ideas.

I play with the fuel pressure and timing and all I get is a start, runs for a few sec, then craps out.

Any suggestions?
make sure VAM wiring is connected. I hate to say it but one time I put the vam on backwards because i wanted so badly to get the car started. Check all vac lines too.
already did both.

The o2 sensor ground wasn't connected, I'm trying that right now and I'll post back
nope, no results. Any other ideas?
Check and make sure all your intercooler lines are hooked and tight. If my FMIC has the least bit of a leak the car stalls immediatly if it starts at all.
got it going it going, Chip was right, the damn VAM was on backwards. I figured I'd look at it as precaution. Live and learn. Thanks for the help.
ok, runs and drives, now I have no boost from the holeset.
hey man are you in PA or CT right now? I had no idea there were anyone close to me in PA, i'm minutes from Willow Grove....

bob
Quote:now I have no boost from the holeset.
WG open?
That was my prob.
Pages: 1 2